Netgear WNAP210 WNAP210 Reference Manual - Page 37
Setting Basic IP Options, Configuration >, DHCP Client, IP Address - dhcp server
UPC - 606449062694
View all Netgear WNAP210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
ProSafe Wireless-N Access Point WNAP210 Reference Manual Setting Basic IP Options Enter the basic IP settings for your wireless access point on this screen. The default settings will work in most cases. However, if your wireless access point is part of a more complex LAN network, then modify these settings to meet the requirements of your network. To configure the basic IP settings of your wireless access point: 1. Select Configuration > IP. The IP Settings screen will display as shown in Figure 2-9. Figure 2-9 2. If necessary, edit the IP address fields of the WNAP210. - DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless access point will get its IP address, subnet mask, and default gateway settings automatically from the DHCP server on your network when you connect the WNAP210 to your LAN. - IP Address. Enter the IP address of your wireless access point. The default IP address is 192.168.0.236. To change it, enter an unused IP address from the address range used on your LAN, or enable DHCP. Installation and Configuration v1.0 March 2009 2-15