Netgear WNAP210 WNAP210 Reference Manual - Page 85
Advanced Configuration, 802.1Q VLAN, 1Q VLAN - bridge mode
UPC - 606449062694
View all Netgear WNAP210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Chapter 4 Advanced Configuration This chapter describes how to configure the advanced features of your ProSafe Wireless-N Access Point. The advanced configuration features are located under various sub-menus under Configuration and provide the following functions: • 802.1Q VLAN. Enabling untagged VLAN operation • Hotspot settings. Enabling HTTP redirect • Wireless settings. Configuring advanced wireless LAN parameters. • Access point settings. Enabling wireless bridge and repeater modes. 802.1Q VLAN The 802.1Q VLAN protocol on the access point logically separates traffic on the same physical network. See Figure . • Untagged VLAN. When this check box is selected, one VLAN can be configured as an untagged VLAN. When the access point sends frames associated with the untagged VLAN out the LAN (Ethernet) interface, those frames will be untagged. When the access point receives untagged traffic from the LAN (Ethernet) interface, those frames are assigned to the untagged VLAN. If this check box is not selected, the access point tags all outgoing LAN (Ethernet) frames. Only incoming frames tagged with known VLAN IDs will be accepted. Note: The Untagged VLAN check box should not be selected only if the hubs or switches on your LAN support the VLAN (802.1Q) standard. Likewise, the Untagged VLAN value should be changed only if the hubs and switches on your LAN support the VLAN (802.1Q) standard. Changing either of these values will result in a loss of IP connectivity if the hubs and switches on your network have not yet been configured with the corresponding VLANs. 4-1 v1.0 March 2009