Oki C830dn User Guide - Page 13
Caution
View all Oki C830dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CAUTION! > IMPORTANT: Set paper size dial (3) to the size and orientation of paper being used (A4 LEF in the above example). > C810 only: GDI printers use the printer settings defined by the host (PC). If the paper is oriented long-edge, the Long Edge Feed (LEF) checkbox must be enabled in the printer driver. If the paper is oriented short-edge, the Long Edge Feed checkbox must be disabled in the printer driver. If the driver setting doesn't match the paper orientation, the printer will display an error message indicating that a mismatch has occurred. 5. If you have two trays and you are printing from the 1st (upper) tray, you can pull out the 2nd (lower) tray during printing to reload it. However, if printing from the 2nd (lower) tray, do not pull out the 1st (upper) tray. This will cause a paper jam. If 3 trays are fitted this applies to trays 1 & 2 if printing from the 3rd (lower) tray. 6. For face down printing, make sure the face up (rear) stacker (3) is closed (the paper exits from the top of the printer). Stacking capacity is approximately 250 sheets, depending on paper weight. 7. For face up printing, make sure the face up (rear) stacker (3) is open and the paper support (4) is extended. Paper is stacked in reverse order and tray capacity is approximately 100 sheets, depending on paper weight. 8. Always use the face up (rear) stacker for heavy paper (card stock etc.). CAUTION! Do not open or close the rear paper exit while printing as it may result in a paper jam. Loading paper > 13