Oki C830dn User Guide - Page 26

COLOR MENU The printer automatically adjusts color balance and density at appropriate intervals, optimising the printed output for bright white paper viewed in natural daylight conditions. The items on this menu provide a means of changing the default settings for special or particularly difficult print jobs. Settings revert to their default values when the next print job is complete. ITEM DENSITY CONTROL ADJUST DENSITY SETTINGS AUTO MANUAL EXECUTE AJST REGSTRATION EXECUTE C REG FINE ADJ M REG FINE ADJ Y REG FINE ADJ -3~0~+3 -3~0~+3 -3~0~+3 EXPLANATION Selecting this will permit automatic adjustment of the color density. Image density will be automatically adjusted at power on, when a new image drum or toner cartridge is installed, and at intervals of 100, 300 and 500 drum counts. If a 500 drum count interval occurs during a print job it will occur at the end of that job, and will take up to 55 seconds. Performs automatic color registration adjustment. Normally this is done on power on and when the top cover is opened and then closed. This process accurately aligns the cyan, magenta and yellow images to the black image. Performs fine adjustment of image timing in relation to the black image component. SYSTEM CONFIGURATION MENU This menu adjusts general printer settings to suit the way you prefer to work. ITEMS POW SAVE DELAY CLRABLE WARNING SETTINGS 5 15 30 60 240 ONLINE JOB MANUAL TIMEOUT WAIT TIMEOUT OFF 30 60 OFF~90~300 TONER LOW CONTINUE JAM RECOVERY CONTINUE STOP ON OFF ERROR REPORT ON OFF EXPLANATION Adjusts the idling time before the printer automatically switches into power saving mode. In this mode power consumption is reduced to a low level required to just keep the printer operating and ready to receive data. When a job is sent the printer will require a warm-up time of up to 1 minute before printing can begin. When ONLINE, non-critical warnings, such as requests for a different paper size, can be cleared by pressing the ON LINE button. When set to JOB, they are cleared when the print job resumes. Specifies how many seconds the printer will wait for paper to be fed before cancelling the job. Specifies how many seconds the printer will wait when received data pauses before forcing a page eject. In PostScript Emulation mode the job will be cancelled if timeout occurs. Specifies whether the printer should continue printing even after a low toner condition is detected. Specifies whether the printer should perform jam recovery after a paper jam has occurred. If ON, the printer will attempt to print again any pages lost due to a paper jam once the jam has been cleared. Sets whether an error report is printed when an internal fault occurs. Menu functions - C810 > 26