Onkyo TX-DS575x Owner Manual - Page 12
Making antenna connections - model 5 1
View all Onkyo TX-DS575x manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Making antenna connections Outdoor antenna Indoor antenna 300 ohms ribbon wire Connecting the antenna cable to the 75/300 ohm antenna adapter (Non-U.S., Canadian and European models) Connecting the 300 ohm ribbon wire: Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver. Connecting the coaxial cable: 1. With your fingernail or a small screwdriver, press the stoppers outward and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit 1 2 3 C. 3. Prepare the coaxial cable as shown in the diagram. Slit B 3 3 33 33 3 33 3 3 636 mm mm mm 15mm Connect the 75/300 ohm antenna adapter to the coaxial cable. 1 Insert the end of the cable. 2 Clamp it in place with pliers. 1 Wire A 4. Re-install the cover. Slit C 2 Directional linkage type splitter To TX-DS575X To TV (or VCR) Directional Iinkage Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter. Assembling the AM loop antenna Assemble the loop antenna as shown in the illustration. • Refer to the next page for details on connecting the AM loop antenna. Insert into the hole. 1 2 Connecting the antenna cable 1. Press down the lever. 2. Insert the wire into the hole. 3. Release the lever to replace it. 12