Onkyo TX-DS838 Owner Manual - Page 18

Connecting antennas Antenna cables 1 3 1. Press down on the lever. 2. Insert the wire. 3. Return the lever. AM loop antenna Assemble the loop antenna as shown in the illustration. (Refer to the next page for details on connecting the AM loop antenna.) Insert into the slot. The 75/300 ohm adaptor is only included with the worldwide model. Outdoor FM/TV antenna Indoor T-shaped antenna 300 ohm ribbon wire 75/300 ohm adaptor (worldwide model only) Connecting the T-shaped antenna or 300 ohm ribbon wire to the 75/300 ohm adaptor Loosen the screws and wrap the wires around them. Then, tighten the screws with a screwdriver. 2 3 Slit B 5 ,3 6, rnmmm mtn 15mm Slit C Wire A Connecting the coaxial cable to the 75/300 ohm adaptor 1. With your fingernail or a small screwdriver, pull the stoppers outwards and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the illustration. Con- nect the coaxial cable to the 75/300 ohm antenna adaptor. (i) Insert the end of the cable. Use pliers to pinch it and keep it in place. 4. Re-install the cover. 18