Onkyo TX-DS838 Owner Manual - Page 4

Precautions Supplied accessories 1. Warranty claim You can find the serial number on the rear panel. In case of warranty claim, please report this number. 2. Recording copyright Recording of copyrighted material for other than personal use is illegal without permission of the copyright holder. 3. AC fuse The fuse is located inside the chassis and is not user-serviceable. If power does not come on, contact your Onkyo authorized service station. 4. Care From time to time you should wipe the front and rear panels and the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth in a weak solution of mild detergent and water, wring it out dry, and wipe off the dirt. Following this, dry immediately with a clean cloth. Do not use rough material, thinners, alcohol or other chemical solvents or cloths since these could damage the finish or remove the panel lettering. 5. Power WARNING BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME, READ THE FOLLOWING SECTION CAREFULLY. • Some models are designed for use only with the power sup- ply voltage of the region where they are sold. U.S. and Canadian models: AC 120 V, 60 Hz European models: AC 230 V, 50 Hz Worldwide model: AC 120 V/220 - 230 V switchable, 50/60 Hz • Voltage selector (Rear panel) Worldwide models are equipped with a voltage selector to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before turning the power button on. (Refer to Setting the voltage selector (worldwide model only) and Setting the tuning step frequency (worldwide model only) on page 5.) Models with- out a voltage selector can only be used in areas where the power supply is the same as that of the unit. 1 Remote control U.S. & Canada: RC-P101S Other areas: RC-P201S 1 AM loop antenna Worldwide model only: 1 75/300 ohm antenna adaptor 2 Batteries (size AA, R6, or UM-3) 1 T-shaped FM antenna O C 1 Conversion plug (Shape may vary according to the area where purchased.) Memory Preservation This unit does not require memory preservation batteries. A built-in memory power back-up system preserves the contents of the memory during power failures and even when the unit is unplugged. The unit must be plugged in order to charge the back-up system. The memory preservation period after the unit has been unplugged varies depending on cl imate and placement of the unit. On the average, memory contents are protected over a period of a few weeks after the last time the unit has been unplugged. This period is shorter when the unit is exposed to a highly humid climate. Dolby Surround Manufactured under license from Dolby Laboratories Licensing Corporation. "Dolby", "AC-3", "Pro Logic" and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Copyright 1992 Dolby Laboratories, Inc. All rights reserved. 4