Onkyo TX-DS838 Owner Manual - Page 22

Multi-Room Remote Control Refer to pages 20 and 21 for connection details. MR OFF MULTI SOURCE -o 0 00, OOO o 0 (6 ,:.4 J I II 0 14/ ,. I I OOO ,c3i p 11 !D•c, !!,DU,O OO c,,M, )io lot j, M !\ 1)) MAIN/SUB VOLUME o oO o o INPUT SELECTOR 1 Indicator off i I 2 MAIN SUB '- a 3 \\ „ C D MULTI SOURCE / \ Blink I 4 TAPE-1 TAPE, TUNER 0 , vi, 0 0 0 0 :PUT SELECTOR .4 ,,,3010 ,,, '0 VOL n VOL Listening from another room In the main room: 1. Press the MR OFF button on the TX-DS838 to make the indi- cator go off. (If the MR OFF indicator is lit, the multi-room system cannot be used.) 2. Set the MAIN/SUB selector switch on the remote control to SUB. 3. Press the appropriate INPUT SELECTOR button on the remote control to select your desired source and start operating it. The MULTI SOURCE indicator in the display lights up. To select a different sub-room source from the main room, press the MULTI SOURCE button on the main unit, then while the MULTI SOURCE indicator flashes, use the input selector buttons to select your desired source. (If an input selector button is pressed while the indicator is off, the main room source will change.) 4 Press the VIII I 'ME A ^r V h.,thsn tp set the MI II CC I iRrE level to its minimum (between -78 and -76 dB). The MULTI SOURCE level appears on the display. In the sub-room, direct the remote control toward the Remote Sensor (Onkyo multi-room system) and: 5. Use the VOLUME • or V button to adjust the volume to the desired level. NOTE: • If the MAIN/SUB selector switch on the remote control is set to MAIN and the MASTER VOLUME control knob is adjusted, the volume level of the speakers in the main room will change, not the speakers in the sub-room. If the remote control is used from the sub-room, but the components cannot be controlled, check the following: • Use the controls on the TX-DS838 in the main room to check whether it is working properly. Then, use the remote control to check whether the component is working properly. If it is not, refer to page 5. • When operating a component not bearing Onkyo's RI mark, check that the emitter is directed toward that component. • Check that the components are correctly connected. • Check that the MR OFF indicator on the TX-DS838 is not lit. 22