Panasonic PT-D6000ULK Functional Instructions - Page 22
Advanced Menu, Digital Cinema Reality, Blanking, Input Resolution, Clamp Position
UPC - 791871111871
View all Panasonic PT-D6000ULK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
ADVANCED MENU Remote control See "Navigating through the menu" on page 15. See "Main menu and Sub-menu" on page 12. DIGITAL CINEMA REALITY You can improve the vertical resolution for PAL (or SECAM) 576i, NTSC 480i, 1080/50i or 1080/60i signals. Press I H to cycle through the options. AUTO OFF 25p FIXED 30p FIXED Detects PAL (or SECAM) 576i, 1080/50i, NTSC 480i and 1080/60i input signals and change the setting properly. Deactive Detects only PAL (or SECAM) 576i and 1080/50i signals, and adjust the vertical resolution of the image to 2:2 pulldown. Detects only NTSC 480i and 1080/60i signals, and adjust the vertical resolution of the image to 2:3 pulldown. NOTE: • 25p FIXED or 30p FIXED setting with signals that is not 2:2 pulldown may result low quality. BLANKING You can perform fine adjustments for blanking if noise appears at the ends of the screen or the image protrudes out of the screen during image projection using a VCR and so on. Press F G to select the edge to adjust, and I H to move the inner edge of the blank. UPPER LOWER Q Setting range Models PT-DZ6710E/PT-DZ6700E PT-DW6300E PT-D6000E Vertical 0 - 599 0 - 399 0 - 383 Horizontal 0 - 959 0 - 639 0 - 511 INPUT RESOLUTION Input resolution adjustment achieves the best image when the screen flickers or halo is observed around the contour, vertical stripes or stuck pixels appear on the screen. Press F G to select the required option to change, and I H to change the value. The initially displayed values vary according to the selected input signal. TOTAL DOTS DISPLAY DOTS TOTAL LINES DISPLAY LINES NOTE: • The vertical stripes will not appear on the all white signal image. • The picture may be distorted during the adjusting operation, but this is not a fault. • The input resolution can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN. • With PT-DW6300E/PT-D6000E, automatic adjustment is not available if signals having a dot clock frequency of more than 150 MHz are supplied. CLAMP POSITION When black part of the image is losing its colour or becomes green, you can adjust to the best colour. Press I H to change the value. Setting range: 0 to 255 NOTE: • Available with signals from RGB 1 IN/RGB 2 IN only. LEFT RIGHT I: Moves the inner edge of the blank area to outside. H: Moves the inner edge of the blank area to inside. Settings ENGLISH - 22