Philips 26PF9966 User manual - Page 44

TROUBLESHOOTING TIPS No Power • Check the TV power cord. Unplug the TV, wait 10 seconds, then reinsert the plug into the outlet and push the POWER button again. • Check that the outlet is not on a wall switch. • Be sure the fuse is not blown on the AC power strip, if one is being used. No Picture • Check antenna/cable connections. Are they properly secured to the TV's ANT 75Ω plug? • Check the TUNER MODE control for the correct tuner set- ting. • Try running the Auto Program feature to find all available channels. • Press the SOURCE button on the remote to make sure the correct signal source is selected. • If using an accessory device, be sure that it is functioning properly. • If in PC Mode, a video signal MUST BE present or the TV will turn off. No Sound • Check the VOLUME buttons. • Check the MUTE button on the remote control. • If you're attempting to hook up auxiliary equipment, check the audio jack connections. TV Only Produces MONO Sound • If using a cable box with RF only type connections, the signal coming from the cable box will be produced in MONO only. • Check Sound control setting. Change setting to Stereo. Remote Does Not Work • Check the batteries. If necessary, replace them with AA Heavy Duty (Zinc Chloride) or Alkaline batteries. • Clean the remote control and the remote control sensor win- dow on the TV. • Check the TV power cord. Unplug the TV, wait 10 seconds, then reinsert the plug into the outlet and push the POWER button again. • Be sure the fuse is not blown on the AC power strip, if one is being used. • Check to be sure the TV outlet is not on a wall switch. • Be sure that the remote is in the correct operating mode. • Be sure the remote is pointed at the Remote Sensor Window on the TV. See page 1 of the Quick Use Guide for details. TV Displays Wrong Channel or No Channels Above 13 • Repeat channel selection. • Add the desired channel numbers (using the CHANNEL EDIT control) into the TV's memory. • Check to be sure the TUNER MODES are set to the CABLE option and run the Auto Program feature to find all available channels. S-VHS color becomes faint • If S-VHS is disconnected, picture color will become faint. To restore picture color, press the CH +/- button on the remote control and do a channel up followed by a channel down. 44