Samsung RF4289HARS Quick Guide (easy Manual) (ver.1.0) (English) - Page 12
Completing The Set Up - doesn t cool
UPC - 036725560529
View all Samsung RF4289HARS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Plastic tubing (A) (Supplied) Refrigerator Compression nut (A) (1/4") (Supplied) Compression fitting (Supplied) 6. After you turn on the refrigerator, let the ice maker make ice for 1 to 2 days. Over that period of time, throw out the first 1 or 2 buckets of ice the freezer makes to ensure all impurities have been removed from the water line. Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 1/4" of the plastic tubing to make sure you get a snug, leak-free connection. Ferrule (Not supplied) Molded end(Bulb) Compression nut (B) (1/4") (Not supplied) Copper tubing or Plastic tubing (B) (Not supplied) (Not supplied) Household water supply line Completing the set up Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and functions of the appliance. By completing the following steps, your refrigerator should be fully operational. 1. Slip the compression nut ( A ) through the supplied plastic tubing ( A ). 2. Tighten the compression nut ( A ) onto the 1/4" compression fitting. - If you are using copper tubing, slip the compression nut ( B ) (not supplied) and ferrule (not supplied) on copper tubing (not supplied) as shown. - If you are using plastic tubing ( B ) , insert the molded end (Bulb) of the plastic tubing ( B ) into the compression fitting. Do not use without the molded end(Bulb) of caution the plastic tubing ( B ). 1. Make sure your refrigerator is in an appropriate location with reasonable clearance between it and the wall. Refer to installation instructions in this manual. 2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors. 3. Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly chilled and the motor will run smoothly. Reset the refrigerator and freezer to the temperatures you want. 4. After you plug the refrigerator in, it will take a few hours to reach the appropriate temperature. You can store food and drinks in the refrigerator after the temperature is sufficiently cool. 3. Tighten the compression nut ( B ) onto the compression fitting. Do not over-tighten the compression nut ( B ) . 4. Turn water on and check for any leakage. If you find water drops or leakage in the connection areas, turn off the main water supply. Check the connections and, if nescessary, tighten. 5. Flush 1 gallon of water through the filter before drinking or using the water from the refrigerator. (Flush approximately 6 minutes.) To flush, press a large glass or cup against the water dispenser lever. Fill the glass, empty it into the kitchen sink after it is filled, and then repeat. 12_ setting up