Samsung SCD303 User Manual (user Manual) (English, Twi) - Page 101

ENGLISH Troubleshooting Troubleshooting ✤ Before contacting a Samsung authorized service center, ✤ perform the following simple checks. They may save you the time and expense of an unnecessary call. Self Diagnosis Display Display Blinking Informs that... Action slow the battery pack is almost discharged. Change to a charged one. TAPE END! slow When the remaining time on the tape is about 2 minutes Prepare a new one. TAPE END! no the tape reached its end. Change to a new one. TAPE! slow there is no tape in camcorder. Insert a tape. PROTECTION! slow the tape is protected from recording. If you want to record, release the protection. ....D L slow the camcorder has some mechanical 1. Eject the tape. fault. 2. Set to OFF. 3. Detach the battery. C 4. Reattach the battery. R * If unresolved contact your local service representative. slow moisture condensation has formed in the camcorder. see below. TAPE END! TAPE END! TAPE! PROTECTION! ....D L C R Moisture Condensation ✤ ✤ If the camcorder is brought directly from a cold place to a warm place, moisture may condense inside the camcorder, on the surface of the tape, or on the lens. In this condition, the tape may stick to the head drum and be damaged or the unit may not operate correctly. ✤ To prevent possible damage under these circumstances, the camcorder is fitted with a moisture sensor. ✤ If there is moisture inside the camcorder, (DEW) is displayed. If this happens, none of the functions except cassette ejection will work. Open the cassette compartment and remove the battery. Leave the camcorder for at least two hours in a dry warm room. 11011