Sharp LC-90LE745U Operation Manual - Page 11
QUICK REFERENCE, Attaching the Stand - tv
View all Sharp LC-90LE745U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
QUICK REFERENCE Attaching the Stand • Before attaching (or detaching) the stand, unplug the AC cord. • Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged. CAUTION • Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. • After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV. • Do not remove the stand from the TV unless using a wall mount bracket to mount it. Before attaching the stand to the TV, build a work table on which to rest the TV. • To build the table, use the cushioning materials used in the packaging. TOP-L 5 The case is equipped with push-in tabs to hold the cushioning materials in place. Push in the tabs (2 for each location) to secure the cushioning materials in the case. Push-in tabs TOP-C FRONT TOP-R • Of the cushioning materials used, TOP-C is also used during stand unit assembly. Be sure to assemble the stand unit before building the work table. ■ Stand Unit Assembly 1 Confirm that there are 12 screws (8 long screws and 4 short screws) supplied with the stand unit. 2 1 Set the post for the stand unit onto the TOP-C. 2 Attach the base to the post. 3 Insert and tighten the 8 screws into the 8 holes on the bottom of the base. • Hold the stand unit securely with one hand, and then tighten the screws. 3 2 ɹɹ 1 1 Long screws 6 After you have built the work table, spread a blanket or similar soft cloth over the table and then lay the TV display down on the covered table. • Do not use a small table for this. ■ Attaching the Stand to the TV 7 Insert the stand into the openings on the bottom of the TV. • Make sure that the stand is firmly inserted into the TV. Improper installation may result in tilting of the TV set. FRONT ■ Building the Work Table 3 Attach the joints and close the case. 1 Insert a joint into the hole on the side of the case. 2 Pressing the tab, fix the joint into place. 1 2 4 Insert each of the cushioning materials in the respective directions shown in the figure. • Insert TOP-L and TOP-R into the left and right sides of the case respectively. • Insert TOP-C to fit between the lines on the other side of the case. TOP-L CASE LINE TOP-R 8 Insert and tighten the 4 screws into the 4 holes on the rear of the TV. Short screws ɹɹɹ • In the installation procedure, be careful not to catch your fingers between the TV set and the floor. JOINT TOP-C 9