Sony DCR-TRV10 Service Manual - Page 144
Mechanism Position, Position, Contents, 2. MSW Code
View all Sony DCR-TRV10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
2-2. MSW Code MSW when errors occur: Information on MSW (mode SW) when errors occur MSW when movement starts: Information on MSW when movements starts when the mechanism position is moved (When the L motor is moved) MSW of target of movement: Information on target MSW of movement when the mechanism position is moved Mechanism Position ← UNLOAD LOAD → EJECT BL USE BL SOFF BL DS BL LE BL STOP BL FF BL RP BL RVS 0011=3 1111=F 1011=B 1111=F 0111=7 1111=F 0101=5 1111=F 1001=9 1111=F 1101=D 1111=F 1100=C 1111=F 1110=E 1111=F 1010=A LS chassis movement range Pinch roller is pressed Releasing lock of cassette compartment Tension regulator ON Position EJECT BL USE SOFF DS LE STOP FF RP RVS NULL Code A F E C D 9 5 7 B 3 0 Contents Position at which the cassette compartment lock is released, and position at the farthest unload side mechanically at which the mechanism can move no further in the UNLOAD direction. BLANK code, at the boundary between codes. The mechanism will not stop at this code during operations. (Excluding LOAD/UNLOAD) EJECT completion position. When the cassette is ejected, the mechanism will stop at this position. Cassette IN standby. The guide will start protruding out as the mechanism moves towards the LOAD position. Code during loading. Code outputs while the LS chassis is moving. LS operations and guide loading are performed here. Current limiter is turned off. Stop position in the loading state. The pinch roller separates, the tension regulator returns, and the brake is imposed on both reels. FF position. The tension regulator is half on. This position is not used except for the FF mode. PB, REC, CUE, Pause, FX2, FWD-SLOW positions. When the pinch roller is pressed, and the tension regulator is ON, the mechanism is operating at this position in modes in which normal images are shown. Reverse running position. REW, REV, RX1, RX2, and RVS-SLOW are performed at this position. Code not existing in the MD. When errors occur when the loading motor is not driving, this code is memorized. 5-58