Sony DVO1000MD User Manual (Instructions For Use) - Page 16

Rear Panel 2 S-VIDEO IN connectors 3 VIDEO IN connectors Overview 1 MAIN POWER switch qd -AC IN connector 1 MAIN POWER switch Switch to the = side to turn the power on. Switch to the a side to turn the power off. Normally you should leave this switch in the on position and power the unit on and off with the power switch on the front panel. Note If you need to turn the main power off when not using the unit for long periods and so on, always set the unit to standby mode with the 1 (on/standby) switch on the front panel before setting the MAIN POWER switch to off. 2 S-VIDEO IN connectors (4-pin mini DIN) The left S-VIDEO IN connector inputs analog S video signals. The two connectors are loop-through connectors. If you connect S video input signals to the left connector, you can bridge-connect the signal to other equipment via the right connector (marked ). Thus the same signals which are input to the left connector are output from the right connector to other equipment. When no connection is made to the right connector, the left connector is terminated automatically with an impedance of 75 Ω. 3 VIDEO IN connectors (BNC type) The left VIDEO IN connector inputs analog composite video signals. The two connectors are loop-through connectors. If you connect composite video signals to the left connector, you can bridge-connect the signal to 4 VIDEO OUT connector 5 S-VIDEO OUT connector 6 MONITOR AUDIO connector 7 AUDIO OUT L/R connectors 8 AUDIO IN L/R connectors 9 REMOTE IN RS-232C connector 0 DV IN (i.LINK) connector qa USB connector qs Equipotential ground terminal connector other equipment via the right connector (marked ). Thus the same signals which are input to the left connector are output from the right connector to other equipment. When no connection is made to the right connector, the left connector is terminated automatically with an impedance of 75 Ω. 4 VIDEO OUT connector (BNC type) This connector outputs analog composite video signals. 5 S-VIDEO OUT connector (4-pin mini DIN) This connector outputs the analog S video signals. 6 MONITOR AUDIO connector (phono jack) This connector outputs monaural audio signals for monitoring. The audio signals to be output from this connector can be selected among from audio channel 1, audio channel 2, or mixed audio signals, using AUDIO MON CH (see page 52) of the SETUP MENU. 7 AUDIO OUT L/R connectors (phono jack) These connectors output analog audio signals. 8 AUDIO IN L/R connectors (phono jack) These connectors input analog audio signals. 9 REMOTE IN RS-232C connector (9-pin) This is a 9-pin RS-232C interface which is compatible with the SVO-9500MD video cassette recorder protocol. 16 Location and Function of Parts