Sony DVO1000MD User Manual (Instructions For Use) - Page 18

Overview Connection Notes • Before making connections, be sure to turn the power of any peripheral equipment off. • Connect the AC power cord last. Connecting External Equipment (1) This section gives a connection example to operate the unit connected to external equipment using a remote control unit (not supplied) and/or foot switch (not supplied). Settings required for using this connection example Make the following settings before operating in this connection example using SETUP MENU. For detailed information on menu operation, see "Basic Menu Operations" on page 55. • Audio output selection Select the audio output channel using the AUDIO MON CH sub menu of SETUP MENU (see page 52). - LCH: Outputs the audio signal of audio channel 1. - RCH: Outputs the audio signal of audio channel 2. - MIX: Outputs a mixed audio signal from both channel 1 and channel 2. (factory setting) • Input signal selection Select the input signal "ANALOG" using the INPUT SELECT sub menu of SETUP MENU (see page 29). • Foot switch mode selection Select the operation mode of the foot switch from among LOW EDGE (factory setting), HIGH EDGE and LOW ACTIVE (see page 33). 1 S-video cable (not supplied) 2 Audio cable (not supplied) 3 Audio cable (not supplied) 4 AC power cord (not supplied) Rear panel S-VIDEO IN 1 To S-video output connector External equipment 2 To analog audio output connector AUIDO IN L/R 1 To S-video input connector S-VIDEO OUT 3 To analog audio input connector Video monitor MONITOR AUDIO 4 to AC outlet - AC IN Front panel REMOTE 1 REMOTE 2 SVRM-100A remote control unit Foot switch 18 Connection