Sony ICD-R100PC ICD-PCLink Software Instructions - Page 56

recorder and check to see if the communication between

Get Sony ICD-R100PC - Icd Recorder PDF manuals and user guides View all Sony ICD-R100PC manuals
Add to My Manuals
Save this manual to your list of manuals

Page 56 highlights

Troubleshooting (continued) 3 Restart the computer. The new setting will activate only if you restart the computer. 4 Start up the ICD-PCLINK Software, connect the cable to the IC recorder and check to see if the communication between the IC recorder and the computer is successful. If a communication error occurs, repeat the above procedure from Step 1 , select a different mode setting in Step 2 and check the operation again. Notes • In some cases the printer port mode setting may be changed when a different application is installed in the computer. In such a case, set the printer port mode again. • If a printer or other devices had been connected to the printer port before using the ICD-PCLINK Software, the printer port mode setting selected in Step 2 may be automatically changed. In such a case, restart the computer. If the communication is still unsuccessful, you need to change the setting. We recommend you make a memo of the setting each time you change the setting. 56

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
56
Troubleshooting (continued)
3
Restart the computer.
The new setting will activate only if you restart the computer.
4
Start up the ICD-PCLINK Software, connect the cable to the IC
recorder and check to see if the communication between the
IC recorder and the computer is successful.
If a communication error occurs, repeat the above procedure from Step
1 ,
select a different mode setting in Step 2 and check the operation
again.
Notes
• In some cases the printer port mode setting may
be changed when a different
application is installed in the computer. In such a case, set the printer port
mode again.
• If a printer or other devices had been connected to the printer port before
using the ICD-PCLINK Software, the printer port mode setting selected in
Step 2 may be automatically changed. In such a case, restart the computer.
If
the communication is still unsuccessful, you need to change the setting.
We recommend you make a memo of the setting each time you change the
setting.