Sony STR-DH540 Operating Instructions - Page 40
USA and Canada models only, Tuning to a station, directly Direct Tuning, Changing the AM tuning, scale - australia
View all Sony STR-DH540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Tuning to a station directly (Direct Tuning) You can enter the frequency of a station directly by using the numeric buttons. 1 Press D.TUNING. 2 Press the numeric buttons to enter the frequency, then press . Example 1: FM 102.50 MHz Select 1 b 0 b 2 b 5 (b 0*) Example 2: AM 1,350 kHz Select 1 b 3 b 5 b 0 * Press 0 for Europe and Australia models only. Tip Adjust the direction of the AM loop antenna (aerial) for optimum reception upon tuning to an AM station. If you cannot tune to a station "- - - .- - MHz" or "- - - - kHz" appears and then the screen returns to the current frequency. Make sure you have entered the right frequency. If not, repeat steps 1 to 3. If you still cannot tune to a station, the frequency may not be in use in your area. Changing the AM tuning scale (USA and Canada models only) You can change the AM tuning scale to either 9 kHz or 10 kHz using the buttons on the receiver. ?/1 TUNING MODE 1 Press ?/1 to turn off the receiver. 2 While holding down TUNING MODE, press ?/1 on the receiver. The current AM tuning scale is changed to 9 kHz (or 10 kHz). To reset the scale to 10 kHz (or 9 kHz), repeat the procedure above. Notes • Depending on the settings, the receiver may take some time to change the AM tuning scale. • All preset stations will be erased when you change the tuning scale. 40GB