Sony VPL DX15 Operating Instructions - Page 21
Before using the Remote, Commander, To replace a battery, Notes on the lithium battery
UPC - 027242762039
View all Sony VPL DX15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Overview For details, see "To Freeze the Image Projected (Freeze)" on page 37. Before using the Remote Commander Pull out the clear film from the lithium battery holder. To replace a battery 1 Pull out the battery cover by a thin stick inserting to a hole, as shown the illustration. Rear 2 Install the lithium battery. Notes on Remote Commander operation • Make sure that nothing obstructs the infrared beam between the Remote Commander and the remote control detector on the projector. Direct the Remote Commander toward the remote control detector. • The operation range is limited. The shorter the distance between the Remote Commander and the remote control detector is, the wider the angle within which the commander can control the projector becomes. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. Face the + side up. 3 Put the lithium battery holder back into the Remote Commander. Notes on the lithium battery • A button type lithium battery (CR2025) is used in the Remote Commander. Do not use batteries other than CR2025. • Keep the lithium battery out of the reach of children. • Should the battery be swallowed, immediately consult a doctor. Remote Commander 21