Sony VPL DX15 Operating Instructions - Page 26

3 Turn on the equipment connected to the projector. 4 Move the lens shutter lever to open the lens shutter. 5 Adjust the upper or lower position of the picture. Use the adjuster to adjust the picture position. Using the adjuster 1 Lift the projector while pressing the Adjuster adjustment button. 2 Adjust the tilt of the projector. 3 Release the Adjuster adjustment button. 4 When fine-tuning is necessary, turn the Adjuster right and left. Press the KEYSTONE key to display "V Keystone" on the screen, and adjust the value with the v/V/b/B keys. The adjusted value is valid until the power is turned off. • Be careful not to let the projector down on your fingers. • Do not push hard on the top of the projector with the adjuster extended. It may cause a malfunction. 6 Adjust the size of the picture and the focus. Adjust the picture size using the Zoom ring and adjust the picture focus using the Focus ring. 7 Press the INPUT key to select the input source. Each time you press the key, the input signal switches as follows: Input signal indicator 2 13 4 Notes • When you adjust the tilt of the projector with the adjuster, the V keystone adjustment is performed at the same time. If you do not want to perform the automatic keystone adjustment, set the "V Keystone" to "Manual." (See page 54.) • If you set the "V Keystone" to "Auto," the "V Keystone" correction is automatically adjusted. However, it may not be perfectly adjusted depending on the room temperature or the screen angle. In this case, adjust it manually. 26 Projecting VPL-DX10/DX11 Input-A Video S-Video VPL-DX15 Input-A Network USB S-Video Video Input signal indicator Shows the selected input channel. x is displayed when no signal is input. You can hide this indicator using "Status" on the Setup menu. To input from Computer connected to the INPUT A connector Press INPUT to display Input-A