TEAC DP-008 DP-008 Owner's Manual - Page 43
Assigning inputs, Using input EQ, Stereo level meters L, R
View all TEAC DP-008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
6 - Basic Recording depend on the operating conditions as shown below. •• REC indicator not lit during playback: track playback signal •• REC indicator blinking (record standby) during playback: track playback signal •• REC indicator blinking (record standby) when the recorder is stopped: track input signal •• REC indicator lit (during recording): track input signal NOTE When the playback signal is shown, the level of the recorded signal of the track is shown, so the level shown by the meters cannot be changed. When the input signal is being shown, the input levels, and thus the meters, can be changed using the TRIM knobs for INPUT A and INPUT B. Stereo level meters (L, R) These show the stereo bus output level of this unit. Adjust the output level with the MASTER LEVEL knob. Assigning inputs When using this unit, "assigning inputs" means setting the recording source for each track to either INPUT A or INPUT B. This unit can simultaneously record a maximum of two tracks. You can also record one input to two tracks simultaneously (in this case, you cannot use the other input). You cannot assign two inputs to the same track. 1 When the recorder is stopped, press ASSIGN to open the INPUT ASSIGN screen. In the initial setting, A (INPUT A) is assigned as the recording source for tracks 1, 3, 5 and 7, and B (INPUT B) is assigned as the recording source for tracks 2, 4, 6 and 8. 2 Use the REC keys to set the input source for each track to either A (INPUT A) or B (INPUT B). 3 When finished making settings, press the HOME key to return to the Home Screen. Using input EQ INPUT A and INPUT B each have a two-band equalizer (EQ). Use the INPUT SETTING screen to set input EQ. 1 Press the INPUT SETTING key to open the INPUT SETTING screen. 2 Press the F2 (EQ) key to open the equalizer setting screen. The input equalizer has the following parameters. Parameter Setting value EQ-SWITCH (input EQ ON/OFF switch) (Default: OFF) Hi-F (high frequency 1.7 kHz - 18 kHz range) (Default: 5 kHz) Hi-G (high range gain) ±12 dB (Default: 0.0 dB) Lo-F (low frequency 32 Hz - 1.6 kHz range) (Default: 350 Hz) Lo-G (low range gain) ±12 dB (Default: 0.0 dB) TASCAM DP-008 43