TP-Link T1500-28PCT TL-SL2428P T1500-28PCT V1 CLI Reference Guide - Page 146
spanning-tree mode
View all TP-Link T1500-28PCT TL-SL2428P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
point-to-point -- The P2P link status, with auto, open and close options. By default, the option is auto. If the two ports in the P2P link are root port or designated port, they can transit their states to forwarding rapidly to reduce the unnecessary forward delay. Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet) Example Enable the STP function of port 1, and configure the Port Priority as 64, ExtPath Cost as 100, IntPath Cost as 100, and then enable Edge Port: T1500-28PCT(config)# interface fastEthernet 1/0/1 T1500-28PCT(config-if)# spanning-tree common-config port-priority 64 e xt-cost 100 int-cost 100 portfast enable point-to-point open spanning-tree mode Description The spanning-tree mode command is used to configure the STP mode of the switch. To return to the default configurations, please use no spanning-tree mode command. Syntax spanning-tree mode { stp | rstp | mstp } no spanning-tree mode Parameter stp --Spanning Tree Protocol, the default value. rstp --Rapid Spanning Tree Protocol mstp --Multiple Spanning Tree Protocol Command Mode Global Configuration Mode Example Configure the spanning-tree mode as mstp: T1500-28PCT(config)# spanning-tree mode mstp 135