Whirlpool MH2175XSB Service Guide - Page 28

Removing The Outer Cabinet

Get Whirlpool MH2175XSB PDF manuals and user guides View all Whirlpool MH2175XSB manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

Removing the Outer Cabinet 7. After removing all the screws, pull each side out and push it back from the front corners of the unit to release the tabs on the inside front edge of the cabinet. IMPORTANT: When you work on the microwave oven, be careful when handling the sheet metal parts. Sharp edges may be present, and you can cut yourself if you are not careful. 1. Unplug microwave oven or disconnect power. 2. Remove the air grille (see page 4-4). 3. Remove the 8 screws visible on the top of the microwave unit. 4. Remove the 1 screw visible on the side. 8. The cabinet may now be completely removed from the unit. 9. CAUTION: Discharge the high-voltage capacitor with a 20,000 Ohm resistor to chassis ground. 5. Remove the 9 screws around the edge of the back panel. 6. Remove the 3 screws on each end of the bottom panel (not shown). 4-10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
4-10
REMOVING THE OUTER CABINET
IMPORTANT:
When you work on the microwave
oven, be careful when handling the sheet metal
parts. Sharp edges may be present, and you
can cut yourself if you are not careful.
1. Unplug microwave oven or disconnect power.
2. Remove the air grille (see page 4-4).
3. Remove the 8 screws visible on the top of the
microwave unit.
4. Remove the 1 screw visible on the side.
5. Remove the 9 screws around the edge of the
back panel.
6. Remove the 3 screws on each end of the bot-
tom panel (not shown).
7. After removing all the screws, pull each side
out and push it back from the front corners of
the unit to release the tabs on the inside front
edge of the cabinet.
8. The cabinet may now be completely removed
from the unit.
9. CAUTION:
Discharge the high-voltage ca-
pacitor with a 20,000 Ohm resistor to chassis
ground.