Xerox 4150S Getting Started Guide - Page 8

Switch On the WorkCentre Once the WorkCentre has been assembled it must be configured. This is done using the Product Enablement Key when the machine is switched on for the first time. The Product Enablement Key is delivered in a plastic tube inside the box with the machine. The procedure to configure the machine is as follows: 1 Locate the tube containing the Product Enablement Key. Remove the plastic card and carefully press out the key. 2 Install the Product Enablement Key into the Card Reader Slot on the left side of the machine. Product Enablement Key Card Reader slot On/Off Switch Green LED Power Cord 3 Connect the Power Cord to the machine and a suitable power supply outlet. 4 Switch on the machine. 5 The Language Default screen will be displayed. Select your chosen language and then select Save. 6 The Installation Wizard screen will be displayed. Select Next. 7 The Product Enablement Settings screen will be displayed. Follow the instructions on the screen. NOTE: When the Green LED light stops blinking and remains on continuously (about 10 seconds), the configuration is successful. Remove the Product Enablement Key and select Next on the display 4 getting started guide