Xerox 6180N Common Controller System Guide v 3.7 - Page 106
Export the trace file to floppy, If you used the compress command above, type
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Hints and Tips System Guide 10. If the file size is greater than 1.44 MB, type compress FileName.txt and press . If the file size is less than 1.44 MB, go to "Export the trace file to floppy". Export the trace file to floppy To export the trace file to a floppy, perform the following: 1. Insert a blank, formatted floppy into the floppy drive. 2. Type volrmmount -i and press . 3. If you used the "compress" command above, type cp FileName.txt.Z /floppy/floppy0 and press . If you did not use the "compress" command above, type cp FileName.txt /floppy/floppy0 and press . 4. Type eject and press . 10-8 Common Controller
Hints and Tips
System Guide
10-8
Common Controller
10.If the file size is greater than 1.44 MB, type
compress
FileName.txt
and press <Enter>. If the file size is less than
1.44 MB, go to “Export the trace file to floppy".
Export the trace file to floppy
To export the trace file to a floppy, perform the following:
1.
Insert a blank, formatted floppy into the floppy drive.
2. Type
volrmmount -i
and press <Enter>.
3.
If you used the "compress" command above, type
cp
FileName.txt.Z /floppy/floppy0
and press <Enter>. If you
did not use the "compress" command above, type
cp
FileName.txt /floppy/floppy0
and press <Enter>.
4. Type
eject
and press <Enter>.