Xerox 6180N Common Controller System Guide v 3.7 - Page 24
Restoring a System, reboot, init 0, boot -s, mount /dev/diskette /a, cd /a, restore
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Backup and Restore System Guide 12. After the backup is complete, restart the system by typing reboot and pressing Enter. Restoring a System Before you begin to restore the system, locate the CD labeled "Solaris 8 CD (1 of 2)" from which to run the Operating System. You will also need a system to restore to (with a QIC tape drive), the XBR floppy, all the backup tapes that were made by the previous procedure, the CD-ROM labeled "Solaris 8 CD (1 of 2)". To restore the system, perform the following: 1. Insert the "Solaris 8 CD (1 of 2)" CD-ROM, the first tape, and the XBR floppy into the system. 2. Open a Terminal window. 3. In the Terminal window, login as root. 4. At the command prompt, type init 0 and press . 5. At the "ok" prompt, type boot -s 6. Once the system reboots, login as root. 7. Create a directory; type mount /dev/diskette /a 8. Type cd /a 9. Type ./xbr (don't forget the "." and "/") 10. Type restore 11. Answer y for yes to the question that comes up. 12. The system will then reboot. 13. Insert each tape as they are asked for and Press . 14. Repeat the previous step twice. 15. The system will reboot. Login as root. 16. As the system requests a new tape, enter the next tape in the sequence into the drive. 17. The system will display a message when the restore is complete. To restart the system, type reboot and press . 3-4 Common Controller