Yamaha HTR-5935 Owners Manual - Page 90
Problem, Cause, Remedy, substantial sound.
View all Yamaha HTR-5935 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
TROUBLESHOOTING Problem Cause Remedy The sound suddenly goes off. Sound is heard from the speaker on one side only. Only the center speaker outputs substantial sound. No sound is heard from the center speaker. No sound is heard from the surround speakers. No sound is heard from the subwoofer. The protection circuitry has been activated because of a short circuit, etc. Check that the speaker impedance setting is correct. Check that the speaker wires are not touching each other and then turn this unit back on. The sleep timer has turned off this unit. Turn on this unit, and play the source again. The sound is muted. Press MUTE or VOLUME +/- on the remote control to resume audio output. Incorrect cable connections. Connect the cables properly. If the problem persists, the cables may be defective. Incorrect settings in "SPEAKER LEVEL". Adjust the "SPEAKER LEVEL" settings. When playing a monaural source with a CINEMA DSP program, the source signal is directed to the center channel, and the front and surround speakers output effect sounds. "CENTER" in "SET MENU" is set to "NONE". Set "CENTER" to "SML" or "LRG". One of the HiFi DSP programs (except for Try another sound field program. 6ch Stereo) has been selected. "SUR. LR" in "SET MENU" is set to "NONE". Set "SUR. LR" to "SML" or "LRG". This unit is in the "STRAIGHT" mode and a monaural source is being played back. Press STRAIGHT (EFFECT) on the front panel so that "STRAIGHT" disappears from the front panel display. "BASS OUT" in "SET MENU" is set to "FRNT" when a Dolby Digital or DTS signal is being played. Set "BASS OUT" to "SWFR" or "BOTH". "BASS OUT" in "SET MENU" is set to "SWFR" or "FRNT" when a 2-channel source is being played. Set "BASS OUT" to "BOTH". The source does not contain lowfrequency bass signals. See page 12 - - 30 17-23 76 75 59 75 35 75 75 86