Yamaha HTR-5935 Owners Manual - Page 92

TROUBLESHOOTING ■ Tuner Problem Cause Remedy FM stereo reception is noisy. There is distortion, and clear reception cannot FM be obtained even with a good FM antenna. The desired station cannot be tuned into with the automatic tuning method. Previously preset stations can no longer be tuned into. The desired station cannot be tuned into with the automatic tuning method. AM There are continuous crackling and hissing noises. There are buzzing and whining noises. The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away or the antenna input is poor. There is multi-path interference. The signal is too weak. This unit has been disconnected for a long period. The signal is weak or the antenna connections are loose. Noises result from lightning, fluorescent lamps, motors, thermostats and other electrical equipment. A TV set is being used nearby. Check the antenna connections. Try using a high-quality directional FM antenna. Use the manual tuning method. Adjust the antenna position to eliminate multi-path interference. Use a high-quality directional FM antenna. Use the manual tuning method. Set preset stations Tighten the AM loop antenna connections and orient it for the best reception. Use the manual tuning method. Use an outdoor antenna and a ground wire. This will help somewhat, but it is difficult to eliminate all noise. Move this unit away from the TV set. See page 22 - 42 - - 42 43, 44 - 42 - - ■ XM Satellite Radio If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the cause and follow the corresponding remedies. Status message Cause Remedy CHECK ANTENNA UPDATING NO SIGNAL LOADING OFF AIR - - - The XM Connect-and-Play digital antenna Check the XM Connect-and-Play digital antenna is not connected to the XM jack of this accessory connections and orient it for the best unit or does not work properly. reception level. The XM user encryption code is being updated. Wait until the encryption code is updated. The signal is too weak. Check the XM Connect-and-Play digital antenna accessory connections and orient it for the best reception level. It takes longer than four seconds for audio Wait until the decoding process has finished. or text data to be decoded. The XM Satellite Radio channel you selected is not currently broadcasting any signals. Check the channel number again or select another XM Satellite Radio channel. The Channel Station ID (SID) is no longer available. No artist name or song title is available. No channels are available for the selected category. Select another channel category by pressing CATEGORY on the front panel (or A-E/CAT. j / i on the remote control) repeatedly. See page 48 - 48 - - 53 88