Yamaha SP2060 SP2060 V1.2 Owners Manual - Page 23
Rear Panel, Ground Screw, AC IN] Connector, NETWORK] Connector, DIGITAL INPUT] Connector AES/EBU
View all Yamaha SP2060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Foreword Introduction to the SP2060 The Controls and Connectors The Controls and Connectors Rear Panel ( º ¡ ™ DIGITAL INPUT AES/EBU OUTPUT 6 5 4 3 2 1 &* & Ground Screw For maximum safety be sure to securely connect the SP2060 ground screw to an earth connection. The supplied power cable has a three-prong plug that will ground the unit when plugged into an appropriately grounded three-prong type AC mains outlet. If the AC outlet is not grounded, be sure to ground the unit by using this ground screw. Correct grounding will effectively eliminate hum noise and interference. * [AC IN] Connector Connect to the AC mains using the supplied AC power cord. First connect the power cord to the SP2060, then insert the power cord plug into an AC outlet. ( [NETWORK] Connector This is a 100Base-TX/10Base-T Ethernet connector for connection to a computer or other device in the network. NOTE • Use a STP (Shielded Twisted Pair) cable for this connection to prevent electromagnetic interference. Since the SP2060 supports Auto MDI/MDI-X, it will automatically detect whether the connected cable is of the straight type or crossover type, and will configure itself to create the optimal connection. Therefore, you can use either a straight or crossover cable. • The maximum length of a cable between a switching hub and the SP2060 is 100 meters. Due to the quality of cables and switching hub performance, however, proper operation at the maximum length cannot be guaranteed in some cases. º [DIGITAL INPUT] Connector (AES/EBU) Connect an output of an AES/EBU (digital signal) compatible device to this XLR-3-31 connector. ¡ [OUTPUT] Connectors These XLR-3-32 balanced connectors output six channel analog audio signals. Connect them to the inputs on amplifiers. ™ [INPUT] Connectors These XLR-3-31 balanced connectors input two channel analog audio signals. Panel Operation Network Settings References SP2060 Owner's Manual 23