Yamaha SP2060 SP2060 V1.2 Owners Manual - Page 24

Foreword Panel Operation Introduction to the SP2060 The Controls and Connectors Panel Operation Basic Operation Changing the parameter values You can adjust the parameter settings, such as EQ, according to the speaker response or the acoustic environment of a particular venue. This section explains how to change the delay time for Output channel 1 as an example. 1. Display the parameter setting you wish to change. To change the delay time, first press the [DELAY] key to switch to the Delay display. Refer to "The Controls and Connectors" on page 22 for information on the relationship between the parameters and keys. OUT 1 ON/OFF = ON 2. Select a channel for which you wish to change the delay time. In this example, press the OUTPUT 1 [SEL] key. 3. Press the [NEXT] key repeatedly until the parameter you wish to change appears on the screen. In this example, select the Time parameter. OUT 1 TIME = 2.67ms 4. Press the [▲ INC]/[▼ DEC] keys to change the parameter value. The parameter value on the screen changes accordingly. [▲ INC] key [▼ DEC] key Press the [▲ INC] key. Hold down the [▲ INC] key. While holding down the [▲ INC] key, press the [▼ DEC] key. Press the [▼ DEC] key. Hold down the [▼ DEC] key. While holding down the [▼ DEC] key, press the [▲ INC] key. The value increases. The value continues to increase as long as you hold down the key. The value continues to increase at a rate more rapid than when you hold down the [▲ INC] key. The value decreases. The value continues to decrease as long as you down the key. The value continues to decrease at a rate more rapid than when you hold down the [▼ DEC] key. This section describes the function of the panel keys and related displays. Confirmation icon SCENE EDIT 01:FOH(Event A) Cursor Some parameters will prompt you to confirm the operation to reflect the change in the value. In this case, a confirmation icon will appear on the display. Press the [NEXT] key to move the cursor to the icon, then press the [YES] key. A message prompts you to confirm. Press the [YES] key to confirm the operation. LEVEL You can view and adjust the Input and Output channel levels. Parameter INPUT A/B/SUM OUTPUT 1-6 Range -∞, -138.00 through +10.00dB -∞, -138.00 through +10.00dB 1. Press the [LEVEL] key to select the Level display. IN A LEVEL =-138.00dB 2. Press the [SEL] key for the target channel. The corresponding channel is selected. The [SEL] key LED for the selected channel lights up. IN B LEVEL =-138.00dB 3. Press the [▲INC]/[▼DEC] keys to adjust the input or output level. IN B LEVEL =-138.00dB NOTE When INPUT A/B LINK is turned On, the parameters for channels A and B are linked and set to the same value automatically. Network Settings References 24 SP2060 Owner's Manual