Yamaha SP2060 SP2060 V1.2 Owners Manual - Page 46
Display Messages, Warning and error messages
View all Yamaha SP2060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Foreword Introduction to the SP2060 The Controls and Connectors References Display Messages Warning and error messages Message Duplicate IP Adr. Illegal MAC Adr. Invalid IP Adr. Network Error No MAC Adr. No Battery Critical Battery Low Battery Recovering Scene Recall Err Saving Failed Param Access Err Param Set Err W.Clk Unlocked DevGrp Sync Err System Error Meaning Duplicate IP addresses. An illegal MAC address has been encountered. The IP address is not set properly. A cable is disconnected, the power to the connected switching hub or router is turned off, or a cable is not in proper condition. MAC address not specified. The internal battery is completely discharged or not installed. The internal battery is almost discharged. Your data may be lost. The backup battery voltage is low. A program update attempt has failed, and the previous program is currently being restored. A scene recall attempt has failed. A save operation has failed. Current setting cannot be displayed. Current setting cannot be changed. A usable word clock signal is not being received or cannot be detected. The device group configuration set via DME Designer does not match the real configuration. A system error has occurred. Action Change the IP addresses so that there are no duplicates. This could be due to a hardware malfunction. Refer this problem to a contact a Yamaha dealer. Set an appropriate network IP address. Connect the cables properly, and make sure that the hub and/or router are operating correctly. This could be due to a hardware malfunction. Refer this problem to a Yamaha dealer. If you turn off the power to the unit, the current settings will be lost and reset to the default values. Stop operating the unit, and contact a Yamaha dealer for battery replacement. If you turn off the power to the unit, the current settings may be lost and reset to the default values. Stop operating the unit, and contact a Yamaha dealer for battery replacement. This does not affect the operation of the unit. However, if you continue using the unit, the settings may be lost and reset to the default values. Contact a Yamaha dealer for battery replacement at your earliest convenience. Do NOT turn power off while the unit is displaying this message. If the update attempt repeatedly fails, there may be a hardware malfunction. Refer this problem to a Yamaha dealer. Recall the scene again. If the problem persists, contact a Yamaha dealer. This could be due to a hardware malfunction. Refer this problem to a Yamaha dealer. Save the current setting by using DME Designer, then initialize the unit. If the problem persists, contact a Yamaha dealer. Recheck all word clock connections and internal parameters. Use DME Designer to go off-line, create a configuration that correctly matches the actual configuration, and then go back on-line to synchronize the configuration. Save the current setting by using DME Designer, then initialize the unit. If the problem persists, contact a Yamaha dealer. * Do NOT turn off the power to the SP2060 while the unit displays the message "DO NOT TURN OFF!" at the bottom of the display. Panel Operation Network Settings References 46 SP2060 Owner's Manual