Yamaha SP2060 SP2060 V1.2 Owners Manual - Page 36

Foreword Introduction to the SP2060 The Controls and Connectors Panel Operation Setting the Last Memory Resume You can select whether at the startup the SP2060 recalls the scene selected before you turned off the power to the device, or it starts up with the same status as when it was shut down last time. The default setting is "ON." OFF: At the startup, the SP2060 will recall the scene select- ed before you turned off the power to the device. ON: The SP2060 will start up with the same status as when it was shut down last time. 1. Press the [UTILITY] key to select the Utility display. The most recently used Utility display will appear. 2. Press the [UTILITY], [NEXT] or [BACK] key repeatedly until the Last Memory Resume page appears. LAST MEM. RESUME ON Displaying the label You can view the label for the SP2060 that you have set on DME Designer. 1. Press the [UTILITY] key to select the Utility display. The most recently used Utility display will appear. 2. Press the [UTILITY], [NEXT] or [BACK] key repeatedly until the Label page appears. The unit displays the label you created on DME Designer. LABEL [FoH L ] NOTE • You cannot edit the label on the SP2060. • Up to 14 characters from the top can be displayed. 3. Press the [▲INC] key so that the SP2060 will start up with the same status as when it was shut down last time. Press the [▼DEC] key so that at the startup the SP2060 will recall the scene selected before you turned off the power to the device. "ON" flashes on the screen. LAST MEM. RESUME ON 4. Press the [NEXT] key to move the cursor to the icon. LAST MEM. RESUME ON 5. Press the [YES] key. A confirmation message will appear. LAST MEM. RESUME ARE YOU SURE? 6. To confirm the operation, press the [YES] key. The selection is applied and the unit returns to the Last Memory Resume page. Panel Operation Network Settings References 36 SP2060 Owner's Manual