Yamaha SP2060 SP2060 V1.2 Owners Manual - Page 27
ROUTING, Input routing
View all Yamaha SP2060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Foreword Introduction to the SP2060 The Controls and Connectors Panel Operation ROUTING Input routing You can select either analog or digital input signals. This selection links to the word clock master setting. You can also route the left channel of an input signal received at the [INPUT A] or [DIGITAL IN] connector to both Input channels A and B. Option ANA A/B ANA A/A DIG L/R DIG L/L Input Signal Selection A signal at the [INPUT A] connector is routed to channel A, and a signal at the [INPUT B] connector to channel B. A signal at the [INPUT A] connector is routed to channels A and B. A left channel signal is routed to channel A, and a right channel signal to channel B. A left channel signal is routed to channels A and B. Word Clock Master Internal clock: 96kHz Incoming AES/ EBU signal HINT You can check the word clock status on the Utility display. See page 37. 1. Press the [ROUTING] key to select the Routing display. INPUT SELECT SOURCE = ANA A/B Output routing You can route Input channel A, B, and SUM signals to the Crossover input. The following three channels are available: • IN A • IN SUM • IN B 1. Press the [ROUTING] key to select the Routing display. OUT 2 SOURCE = IN A 2. Press the [SEL] key for the target Output channel. The [SEL] key LED for the selected channel lights up. The [SEL] key LED for each channel that shares the same component flashes. The selected channel name appears on the display. OUT 4 SOURCE = IN A 3. Press the [▲INC]/[▼DEC] keys to select an input source to be routed to the Crossover. OUT 4 SOURCE = IN SUM 2. Press the [▲INC]/[▼DEC] keys to select an input signal source. INPUT SELECT SOURCE = ANA A/A NOTE Signals are muted while they are switched between analog and digital to avoid noise. Panel Operation Network Settings References SP2060 Owner's Manual 27