Zenith Z50PX2D Operating Guide - Page 16

Installation HDSTB Setup - This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. - This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). HDMI /DVI (VIDEO) INPUT DIGITAL AUDIO OPTICAL OUTPUT RS-232C INPUT (CONTROL/SERVICE) RGB/DVI AUDIO INPUT REMOTE CONTROL RGB INPUT AC INPUT DVD /DTV INPUT COMPONENT INPUT 2 COMPONENT INPUT 1 L R VIDEO AUDIO RGB / DVI AUDIO INPUT REMOTE CONTROL RGB INPUT AC INPUT (R) AUDIO (L) DIGITAL AUDIO OPTICAL DVI-DTV OUTPUT HDMI-DTV OUTPUT or DIGITAL AUDIO OPTICAL (R) AUDIO (L) B R RGB-DTV OUTPUT (R) AUDIO (L) or Digital Set-top Box How to connect Use the TV's COMPONENT (Y, PB, PR) INPUT, RGB or HDMI/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use 1. Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box.) 2. Use TV/VIDEO on the remote control to select Component 1, Component 2, RGB-DTV, or HDMI/DVI source. Signal 480i 480p 720p 1080i Component 1/2 Yes Yes Yes Yes RGB-DTV , HDMI/DVI No Yes Yes Yes 16 Plasma TV