eMachines D620 Service Guide - Page 83
Reconnect the DIMM., LCD inverter ID
View all eMachines D620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Error Message List Error Messages No beep, power-on indicator turns off and • LCD is blank. • • • • No beep, power-on indicator turns on and • LCD is blank. • • • • • • • No beep, power-on indicator turns on and • LCD is blank. But you can see POST on an • external CRT. • • • • No beep, power-on indicator turns on and a • blinking cursor shown on LCD during • POST. No beep during POST but system runs • correctly. • Check or do the following in sequence: Power source (battery pack and power adapter). See "Power System Check" on page 89. Ensure every connector is connected tightly and correctly. Reconnect the DIMM. LED board Mainboard Power source (battery pack and power adapter). See "Power System Check" on page 89. Reconnect the LCD connector Hard disk drive LCD inverter ID LCD cable LCD Inverter LCD Mainboard Reconnect the LCD connectors. LCD inverter ID LCD cable LCD inverter LCD Mainboard Ensure every connector is connected tightly and correctly. Mainboard Speaker Mainboard Chapter 4 93