Home » eMachines Manuals » Desktops » eMachines EL1360 » Manual Viewer

eMachines EL1360 User Guide - Page 64

Notice for New Zealand - user manual

Add to My Manuals
Save this manual to your list of manuals

Page 64 highlights

Appendix A: Regulations and safety notices Notice for New Zealand 1 The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the item complies with minimum conditions for connection to its network. It indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item will work correctly in all respects with another item of Telepermitted equipment of a different make or model, nor does it imply that any product is compatible with all of Telecom's network services. 2 This equipment is not capable, under all operating conditions, of correct operation at the higher speeds for which it is designed. Telecom will accept no responsibility should difficulties arise in such circumstances. 3 Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. The associated equipment shall be set to operate within the following limits for compliance with Telecom's Specifications: a There shall be no more than 10 call attempts to the same number within any 30 minute period for any single manual call initiation, and b The equipment shall go on-hook for a period of not less than 30 seconds between the end of one attempt and the beginning of the next call attempt. 4 Some parameters required for compliance with Telecom's Telepermit requirements are dependent on the equipment (PC) associated with this device. In order to operate within the limits for compliance with Telecom's specifications, the associated equipment shall be set to ensure that automatic calls to different numbers are spaced such that there is not less than 5 seconds between the end of one call attempt and the beginning of another. 5 This equipment shall not be set up to make automatic calls to Telecom's 111 Emergency Service. 6 This device is equipped with pulse dialing while the Telecom standard is DTMF tone dialing. There is no guarantee that Telecom lines will always continue to support pulse dialing. 7 Use of pulse dialing, when this equipment is connected to the same line as other equipment, may give rise to bell tinkle or noise and may also cause a false answer condition. Should such problems occur, the user should NOT contact the telecom Fault Service. 8 This equipment may not provide for the effective hand-over of a call to another device connected to the same line. 9 Under power failure conditions this appliance may not operate. Please ensure that a separate telephone, not dependent on local power, is available for emergency use. 54

Section	Page
Contents	9
Checking Out Your Computer	11
About this guide	12
Front	12
Back	13
Setting Up and Getting Started	15
Working safely and comfortably	16
Avoiding discomfort and injury from repetitive strain	16
Preparing power connections	16
Protecting from power source problems	16
Checking the voltage selection	17
To set the voltage selection switch:	17
Connecting to a broadband modem or network	18
To connect to a broadband modem or to an Ethernet network:	18
Connecting a dial-up modem	18
To connect the modem:	18
Using the World Wide Web	19
Connecting to a Web site	19
To connect to a Web site:	19
Downloading files	20
To download files or programs from a Web site:	20
Ethernet networking	21
Wired Ethernet networking	21
Ethernet, Fast Ethernet, or Gigabit Ethernet	21
Using a router	22
Example router-based Ethernet network	22
Equipment you need for a router-based Ethernet network	23
Determining if an Ethernet card is already installed on your computer	24
Setting up wired Ethernet network hardware	24
Making sure your broadband connection works	24
Installing Ethernet cards and drivers	24
Connecting network cables	25
Setting up a network using a router	25
To set up a network using a router:	26
Establishing your Ethernet network connection	27
Naming the computers and the workgroup	27
Configuring the TCP/IP protocol	27
Using a DHCP server	27
Configuring your router	27
Testing your network	28
Adding a printer to your network	28
Sharing resources	28
Sharing drives and printers	28
Sharing drives or folders	29
To share drives or folders:	29
Un-sharing drives and folders	29
To un-share drives or folders:	29
Using the network	30
Creating a shortcut to a network drive	30
Opening files across the network	30
To open files across the network:	30
Copying files across the network	30
To copy files across the network:	30
Printing files across the network	31
To print files across the network:	31
Troubleshooting	33
First steps	34
Troubleshooting	34
Add-in cards	35
The computer does not recognize an add-in card	35
Audio	35
CD or DVD drives	35
DVD drives	35
Ethernet	35
You cannot see the other computers on your network	35
The computer does not recognize an add-in Ethernet card	36
Your Ethernet network is running slower than you expect	36
Expansion cards	36
The computer does not recognize an expansion card	36
File management	37
A file was accidentally deleted	37
To restore deleted files:	37
Hard drive	37
You see an “Insufficient disk space” error message	37
You see a “Data error” message	38
The hard drive cannot be accessed, or you see a “General failure reading drive C” error message	38
You see a “Non-system disk” or “disk error” error message	38
Internet	38
You cannot connect to the Internet	38
You see an “Unable to locate host” message and are unable to browse the Internet	39
Connecting to a Web site takes too long	39
People are sending you e-mail messages, but you have not received any mail	39
Keyboard	40
The keyboard does not work	40
A keyboard character keeps repeating or you see a “keyboard stuck” or “key failure” error message	40
Liquid spilled in the keyboard	40
Memory	40
You see a “Memory error” message	40
You see a “Not enough memory” error message	41
Memory card reader	41
Drive letters for the memory card slots do not appear in the My Computer window	41
Modem (cable or DSL)	41
Modem (dial-up)	41
Your modem does not dial or does not connect	41
You cannot connect to the Internet	42
Your 56K modem does not connect at 56K	43
Your fax communications program only sends and receives faxes at 14,400 bps when you have a 56K modem	43
The modem is not recognized by your computer	43
The modem is noisy when it dials and connects	44
Monitor	44
The screen resolution is not correct	44
The computer is running but there is no picture	44
The color is not uniform	44
The text on the display is dim or difficult to read	44
Mouse	45
The mouse does not work	45
The mouse works erratically	45
Networks	45
You cannot connect to your company network	45
Optical disc drives	46
The computer does not recognize a disc or the CD or DVD drive	46
An audio CD does not produce sound	46
A DVD movie will not play	47
Passwords	47
Your computer does not accept your password	47
Power	48
Your computer will not turn on	48
Printer	48
The printer will not turn on	48
The printer is on but will not print	48
You see a “Printer queue is full” error message	49
You see a “Printer is out of paper” error message	49
Sound	49
You are not getting sound from the speakers	49
Audio and Video Set up Procedures	49
Recovering your system	52
To recover your system:	52
Creating recovery discs	53
To create recovery discs:	53
Recovering pre-installed software and drivers	54
To recover your pre-installed software and drivers:	54
Returning your system to its factory condition	55
Recovering from within Windows OS	55
To reinstall Windows OS and all pre-installed software and drivers:	55
Recovering from the hard drive during startup	56
To reinstall Windows OS and all pre-installed software and drivers:	56
Recovering from your recovery discs	56
To reinstall Windows OS and all pre-installed software and drivers:	56
Telephone support	57
Before calling Customer Care	57
Self-help	58

Match case Limit results 1 per page

Appendix A: Regulations and safety notices

Notice for New Zealand

The grant of a Telepermit for any item of terminal equipment indicates only that

Telecom has accepted that the item complies with minimum conditions for

connection to its network. It indicates no endorsement of the product by Telecom,

nor does it provide any sort of warranty. Above all, it provides no assurance that

any item will work correctly in all respects with another item of Telepermitted

equipment of a different make or model, nor does it imply that any product is

compatible with all of Telecom's network services.

This equipment is not capable, under all operating conditions, of correct

operation at the higher speeds for which it is designed. Telecom will accept no

responsibility should difficulties arise in such circumstances.

Some parameters required for compliance with Telecom's Telepermit

requirements are dependent on the equipment (PC) associated with this device.

The associated equipment shall be set to operate within the following limits for

compliance with Telecom's Specifications:

There shall be no more than 10 call attempts to the same number within any

30 minute period for any single manual call initiation, and

The equipment shall go on-hook for a period of not less than 30 seconds

between the end of one attempt and the beginning of the next call attempt.

Some parameters required for compliance with Telecom's Telepermit

requirements are dependent on the equipment (PC) associated with this device. In

order to operate within the limits for compliance with Telecom's specifications,

the associated equipment shall be set to ensure that automatic calls to different

numbers are spaced such that there is not less than 5 seconds between the end of

one call attempt and the beginning

of another.

This equipment shall not be set up to make automatic calls to Telecom's 111

Emergency Service.

This device is equipped with pulse dialing while the Telecom standard is DTMF

tone dialing. There is no guarantee that Telecom lines will always continue to

support pulse dialing.

Use of pulse dialing, when this equipment is connected to the same line as other

equipment, may give rise to bell tinkle or noise and may also cause a false answer

condition. Should such problems occur, the user should NOT contact the telecom

Fault Service.

This equipment may not provide for the effective hand-over of a call to another

device connected to the same line.

Under power failure conditions this appliance may not operate. Please ensure that

a separate telephone, not dependent on local power, is available for emergency

use.