2011 Acura RL Owner's Manual - Page 184

Keyless Access System To turn the ignition switch to the LOCK (0) position, put the transmission in Park, press the switch in, and turn it to the LOCK (0) position. When the transmission is not in Park, you cannot turn the ignition switch to the LOCK (0) position. Before leaving the vehicle, make sure the ignition switch is in the LOCK (0) position. If you open the driver's door with the ignition switch in the ACCESSORY (I) position, a beeper will sound. You will also see a ''RETURN IGNITION SWITCH TO LOCK (0) POSITION'' message on the multiinformation display. Also, if you close the door when the ignition switch is not in the LOCK (0) position and the remote is not inside the vehicle, the keyless access alarm sounds outside the vehicle, a message appears on the multiinformation display, and the beeper sounds if the ignition switch is in the ON (II) position. When the beeper sounds after you close the driver's door outside the vehicle, check the position of the ignition switch and the location of the remote. If the engine is running and you remove the remote from the vehicle, it will continue to run. But once turned to the LOCK (0) position, the engine will not restart until a remote is brought back into the vehicle. Removing the Ignition Switch Cover IGNITION SWITCH COVER pull push BUILT-IN KEY To remove the ignition switch cover, insert the built-in key (see page 181 ), then pull the cover out by pulling the built-in key while pushing it. 178