2011 Acura RL Owner's Manual - Page 515

Malfunction Indicator Lamp If this indicator comes on while driving, or if you see a ''CHECK EMISSION SYSTEM'' message on the multi-information display, it means one of the engine's emissions control systems may have a problem. Even though you may feel no difference in your vehicle's performance, it can reduce your fuel economy and cause increased emissions. Continued operation may cause serious damage. If you have recently refueled your vehicle, the indicator coming on could be due to a loose or missing fuel fill cap. You will also see a ''TIGHTEN FUEL CAP'' message on the multi-information display. Tighten the cap until it clicks at least once (see page 385 ). Tightening the cap will not turn the indicator off immediately; it can take several days of normal driving. If the indicator comes on repeatedly, even though it may go off as you continue driving, have the vehicle checked by your dealer as soon as possible. If the battery in your vehicle has been disconnected or gone dead, these codes may be erased. It can take several days of driving under various conditions to set the codes again. To check if they are set, turn the ignition switch to the ON (II) position, without starting the engine. The malfunction indicator lamp will come on for 20 seconds. If it then goes off, the readiness codes are set. If it blinks five times, the readiness codes are not set. If possible, do not take your vehicle for an emissions test until the readiness codes are set. Refer to Emissions Testing for more information (see page 537 ). If you keep driving with the malf unction indicator lamp on, you can damage your vehicle's emissions controls and engine. Those repairs may not be covered by your vehicle's warranties. The malfunction indicator lamp may also come on with the ''D'' indicator. Readiness Code Your vehicle has certain ''readiness codes'' that are part of the on-board diagnostics for the emissions systems. In some states, part of the emissions testing is to make sure these codes are set. If they are not set, the test cannot be completed. Taking Care of the Unexpected 509