2011 Acura RL Owner's Manual - Page 185
2011 Acura RL Manual
Page 185 highlights
Keyless Access System Beeper and Message Keyless Remote Not Detected The outside beeper sounds when the ignition switch is in the ACCESSORY (I) or the ON (II) position. When the ignition switch is in the ON (II) position, the multiinformation display shows ''KEYLESS REMOTE NOT DETECTED,'' and the inside and outside beepers sound. The multi-information display message goes away when you bring the remote back inside the vehicle, and close the door or apply the parking brake. If the engine is running and you remove the remote from the vehicle, it will continue to run. Once turned to the LOCK (0) position, the engine will not restart until a remote is brought back into the vehicle. The engine does not restart if you turn the ignition switch to the LOCK (0) position when the remote is outside the vehicle. Check where the remote is. Make sure that you carry the remote or built-in key with you when you operate the ignition switch. If you pass the remote through an open window, the system does not respond. Also, even when the remote is inside the vehicle, the beeper may sound when the location of the remote is not detected due to surrounding conditions. It is not a failure. Make sure that you carry the remote with you. Instruments and Controls When you are pressing the ignition switch, or when the ignition switch is in the ON (II) position, the beeper sounds if you take the remote out of the vehicle and close the door. CONTINUED 179