1998 Chevrolet Corvette Owner's Manual - Page 102

Resuming a Set Speed Suppose you set your cruise control at a desired speed and then you apply the brake or clutch pedal. This, of course, disengages thecruise control. But you don't need to reset it. 25 m hor Once you're going about mph (40 k / ) more, R/A you can move the cruise control switch to (Resume/Accelerate) for about half a second. The Driver Information Center (DIC) will display the cruise set speed. You'll go right back up your chosen speed and to stay there. Increasing Speed While Using Cruise Control There are two ways to go a higher speed: to 2. Move the cruise switch R/A. Hold it there until to you get up to the speed you want, then release the switch. To increase your speedin very small amounts, move the switch R/A for less than half a to second, then release Each time youdo this, your it. vehicle will go about1 mph (1.6 km/h) faster. The DIC will display the cruise speed. set Reducing Speed While Using Cruise Control There are two ways to reduce your speed while using cruise control: Push in the button at the end the lever until you of reach the lower speed you want, then release it. The Driver Information Center (DIC) will display the cruiseset speed. To slow down in very small amounts, push the button for less than half a second. Each you do time this, you'll go 1 mph (1.6 km/h) slower. The DIC will display the cruise speed. set 1. Use the accelerator pedal to get to the higher speed. The speedwill not begin to increase until sufficient of pedal travel is achieved. Push button at the end the the lever, then release the button and accelerator the pedal. You'll now cruise at the higher speed. The Driver Information Center (DIC) will display the cruise set speed. 2-49