1998 Chevrolet Corvette Owner's Manual - Page 286
1998 Chevrolet Corvette Manual
Page 286 highlights
Extended Mobility Tires Your vehicle, whennew, had Goodyear Extended Mobility Tires (EMT). There's spare tire, no tire no changing equipment andno place to store a tire in the vehicle. Extended MobilityTires perform so well without any air that a Pressure Monitor (TPM) is Tire used to alert you if a tire lost pressure. has The TirePressure Monitor (TPM) has a sensor on each road wheel thattransmits to a receiver on the instrument panel. The system operates on a radio frequency subject to Federal CommunicationsCommission (FCC) Rules and with Industry and Science Canada. Changes or modifications to this system by other than an authorized service facility could void authorization to use this equipment. If a tire'sinflation pressure is between 5 psi (35 kPa) and 25 psi (170 kPa), you will see a message on the Driver Information Center. This message will show which tire is underinflated and two chimes will sound. An example would be LOW TIRE PRESSURE-LR. This would mean that the inflation pressure in your left rear tire is between 5 psi (35 P a ) and 25 psi (170 P a ) . If the inflation pressure in the tire drops below 5 psi (35 E a ) , the message would read FLAT TIRE-LR and four chimes will sound. See "Driver Information Center" in the Index. The TPM will also alert you if a tire'spressure is higher than 42 psi (290 Wa). Themessage will show which tire is overinflated and two chimes will sound. An example would be HIGH PRESSURE-LR. This would mean that the inflation pressure in your left rear tire is higher than 42 psi (290 kPa). See "Driver Information Center" in the Index. If a tire pressure message appears on the Driver Information Center, stop as soon as you can. Have the tire pressures checked and set to those shown on your Tire Loading Information label. See "Inflation -- Tire Pressure" in the Index. This device complies withPart 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with RSS-210 of Industry and Science Canada. Operationis subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference received,including interference that may device. cause undesired operation of the