2010 Chevrolet Camaro Owner's Manual - Page 242

9-10 Vehicle Care 6.2 L V8 Engine Cover (L99 Engine shown LS3 similar) Engine Oil Checking Engine Oil It is a good idea to check the engine oil level at each fuel fill. In order to get an accurate reading, the oil must be warm and the vehicle must be on level ground. The engine oil dipstick handle is a yellow loop. See Engine Compartment Overview on page 9-6 for the location of the engine oil dipstick. 1. Turn off the engine and give the oil several minutes to drain back into the oil pan. If this is not done, the oil dipstick might not show the actual level. 2. Pull out the dipstick and clean it with a paper towel or cloth, then push it back in all the way. Remove it again, keeping the tip down, and check the level. When to Add Engine Oil If the oil is below the cross-hatched area at the tip of the dipstick, add at least one liter/quart of the recommended oil. This section explains what kind of oil to use. For engine oil crankcase capacity, see Capacities and Specifications on page 11-2. Notice: Do not add too much oil. If the engine has so much oil that the oil level gets above the cross-hatched area that shows the proper operating range, the engine could be damaged. To remove: 1. Remove the engine oil fill cap (A). 2. Lift the engine cover (B) to disengage two front attachment points. 3. Pull engine cover forward to disengage from horizontal rear attachments. 4. Reverse Steps 1 through 3 to reinstall engine cover. See Engine Compartment Overview on page 9-6 for the location of the engine oil fill cap. Add enough oil to put the level somewhere in the proper operating range. Push the dipstick all the way back in when through.