2010 Chevrolet Camaro Owner's Manual - Page 263

Vehicle Care What to Use For 218 mm rear drive module (RDM) V6 manual, V8 automatic and V8 manual: To add lubricant when the level is low, use 75W-90 LS gear oil (GM Part No. US 89021677 and 1052358, in Canada Part No. 89021678 and 992694) meeting GM Specification 9986226. To completely refill after draining, see Recommended Fluids and Lubricants on page 10-7. Then fill to the bottom of the filler plug hole with the Synthetic Gear Lubricant. For 195 mm RDM V6 automatic: To add lubricant when the level is low, use 75W-90 gear Oil (GM Part No. US 89021677, in Canada Part No. 89021678) meeting GM Specification 9986115. To completely refill after draining, see Recommended Fluids and Lubricants on page 10-7. Then fill to the bottom of the filler plug hole with the Synthetic Gear Lubricant. 9-31 Starter Switch Check { WARNING When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room around the vehicle. 2. Firmly apply both the parking brake and the regular brake. See Parking Brake on page 8-32. Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts. 3. For automatic transmission vehicles, try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral). If the vehicle starts in any other position, contact your dealer/retailer for service. For manual transmission vehicles, put the shift lever in Neutral, push the clutch pedal down halfway, and try to start the engine. The vehicle should start only when the clutch pedal is pushed down all the way to the floor. If the vehicle starts when the clutch pedal is not pushed all the way down, contact your dealer/retailer for service.