2012 Chevrolet Corvette Owner's Manual - Page 178

5-64 Instruments and Controls Locate the "Learn" or "Smart" button. It can usually be found where the hanging antenna wire is attached to the motor-head unit and may be a colored button. Press this button. After pressing this button, complete the following steps in less than 30 seconds. 4. Immediately return to the vehicle. Press and hold the Universal Home Remote button that will be used to control the garage door until the garage door moves. The indicator light, above the selected button, should slowly blink. This button may need to be held for up to 20 seconds. 5. Immediately, within one second, release the button when the garage door moves. The indicator light blinks rapidly until programming is complete. 6. Press and release the same button again. The garage door should move, confirming that programming is successful and complete. To program another Rolling Code device such as an additional garage door opener, a security device, or home automation device, repeat Steps 1 through 6, choosing a different function button in Step 4 than what was used for the garage door opener. If these instructions do not work, the garage door opener is probably a Fixed Code unit. Follow the programming instructions that follow for a Fixed Code garage door opener. 2. From inside the vehicle, press the two outside buttons at the same time for one to two seconds, and immediately release them. 3. Locate in the garage, the garage door opener receiver (motor-head unit).