2014 Chrysler Town & Country Owner Manual - Page 236

234 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 3. Push the multifunction lever away from you to switch 3. Rotate the headlight switch clockwise from the AUTO to the on position. the headlights to the high beam position. Refer to "Multifunction Lever" in this section for further inforBattery Protection mation. This feature provides battery protection to avoid wearing NOTE: This system will not activate until the vehicle is down the battery if the headlights, parking lights, or at, or above, 25 mph (40 km/h). front fog lights are left on for extended periods of time when the ignition switch is in the LOCK position. After To Deactivate eight minutes of the ignition switch being in the LOCK Perform either of the following steps to deactivate the position and the headlight switch in any position other Automatic High Beam system. than OFF or AUTO, the lights will turn off automatically 1. Select "Automatic High Beams - OFF" through the until the next cycle of the ignition switch or headlight EVIC. Refer to "Electronic Vehicle Information Center switch. (EVIC)/Customer-Programmable Features" in "UnThe battery protection feature will be disabled if the derstanding Your Instrument Panel" for further inforignition switch is turned to any other position other than mation. LOCK during the eight minute delay. 2. Pull the multifunction lever toward you to switch the headlights from the high beam to the low beam position.