2014 Chrysler Town & Country Owner Manual - Page 582

580 WHAT TO DO IN EMERGENCIES If the sealant (white fluid) does flow through the If the tire does not inflate to at least 26 psi (1.8 Bar) Sealant Hose (6): pressure within 15 minutes: 1. Continue to operate the pump until sealant is no longer flowing through hose (typically takes 30 - 70 seconds). As the sealant flows through the Sealant Hose (6), the Pressure Gauge (3) can read as high as 70 psi (5 Bar). The Pressure Gauge (3) will decrease quickly from approximately 70 psi (5 Bar) to the actual tire pressure when the Sealant Bottle (1) is empty. • The tire is too badly damaged. Do not attempt to drive the vehicle further. Call for assistance. NOTE: If the tire becomes over-inflated, press the Deflation Button to reduce the tire pressure to the recommended inflation pressure before continuing. If the tire inflates to the recommended pressure or is at least 26 psi (1.8 Bar) pressure within 15 minutes: 2. The pump will start to inject air into the tire immediately after the Sealant Bottle (1) is empty. Continue to 1. Press the Power Button (4) to turn off the TIREFIT kit. operate the pump and inflate the tire to the pressure 2. Remove the Speed Limit sticker from the top of the indicated on the tire pressure label on the driver-side Sealant Bottle (1) and place the sticker on the instrulatch pillar (recommended pressure). Check the tire ment panel. pressure by looking at the Pressure Gauge (3).