2014 Chrysler Town & Country Owner Manual - Page 56

54 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • If the power sliding side door is not in the full open or close position, it will fully open when a power sliding door switch is pressed. To close the door, wait until it is fully open and then press the switch again. Power Sliding Side Door Open Flash The left and right exterior hazard lights will flash for 12 seconds when either sliding door is opened. This will alert other drivers in the area that passenger(s) could be • If the power sliding door encounters multiple obstruc- entering or exiting the vehicle. tions within the same cycle, the system will automati- The Sliding Side Door Open Flash can be enabled or cally stop, the power sliding door motor will make a disabled by performing the following procedure: clicking sound until the door has no further movement. This clicking sound can be stopped by pulling 1. Place the Key Fob in the ignition switch. the inside or outside handle. If this condition occurs, 2. Cycle the ignition switch from ON/RUN to OFF five no damage is done to the power sliding door motor. times ending in the ON/RUN position (do not start The power sliding door must be opened or closed the engine). manually. 3. Within 10 seconds of the final cycle, press the HAZARD switch ON. WARNING! You, or others, could be injured if caught in the path of the sliding door. Make sure the door path is clear before closing the door. 4. A single chime will sound to signify that you have successfully completed the programming.