2014 Chrysler Town & Country Owner Manual - Page 273

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 271 If you unplugged the garage door opener/device for Using HomeLink® programming, plug it back in at this time. To operate, press and release the programmed HomeLink® button. Activation will now occur for the Reprogramming A Single HomeLink® Button programmed device (i.e., garage door opener, gate operaTo reprogram a channel that has been previously trained, tor, security system, entry door lock, home/office lightfollow these steps: ing, etc.,). The hand-held transmitter of the device may 1. Cycle the ignition to the ON/RUN position. also be used at any time. 2. Press and hold the desired HomeLink® button until Security the indicator light begins to flash after 20 seconds. Do It is advised to erase all channels before you sell or turn not release the button. in your vehicle. 3. Without releasing the button proceed with To do this, press and hold the two outside buttons for 20 "Canadian/Gate Operator Programming" step 2 and seconds until the red indicator flashes. Note that all chanfollow all remaining steps. nels will be erased. Individual channels cannot be erased. The HomeLink® Universal Transceiver is disabled when the Vehicle Security Alarm is active. 3