2009 Dodge Challenger Owner's Manual - Page 344
2009 Dodge Challenger Manual
Page 344 highlights
342 WHAT TO DO IN EMERGENCIES Sealing Tire with TIREFIT 1. Turn on the Hazard Warning Flashers. 8. Leave the parking brake set and the shift lever in PARK (automatic transmission) or NEUTRAL (manual transmission) and start the engine. 2. Move the shift lever into PARK (automatic transmis9. Press the switch 3 on the air pump to I (ON). The air sion) or in gear (manual transmission), turn OFF the pump should start to inflate the tire and the tire sealant engine and set the parking brake. (white fluid) will flow from the sealant bottle 5 through 3. Remove the TIREFIT kit from the trunk. the TIREFIT sealant hose 6 and into the tire. 4. Pull the power plug 2 and the TIREFIT sealant hose 6 10. Allow the air pump to run for five minutes and then out from the TIREFIT kit. read the pressure gauge 4. If the tire inflates to 26 psi (1.8 bar) or greater, proceed to Step 19 of this procedure. 5. Unscrew the valve cap from the valve on the deflated If not, proceed to the following step. tire. 11. Press the AIR PUMP switch 3 to 0 (OFF). Then, 6. Screw the fitting at the end of TIREFIT sealant hose 6 disconnect the TIREFIT system from the tire and place it coming from the sealant bottle 5 onto the tire valve. back in the vehicle. 7. Insert the power plug 2 into the power point on the 12. Release the parking brake and drive the vehicle back instrument panel. and forth approximately 30 ft (9.1 m) to distribute the sealant more evenly within the tire.