2009 Dodge Challenger Owner's Manual - Page 45
2009 Dodge Challenger Manual
Page 45 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 43 chime and flash the Seat Belt Reminder Light for 96 seconds or until the driver's seat belt is buckled. The BeltAlert will be reactivated if the driver's seat belt is unbuckled for more than 10 seconds and the vehicle speed is greater than 5 mph (8 km/h). NOTE: You must perform the following steps within 60 seconds of turning the ignition switch to the ON position. 3. Within 60 seconds of turning the ignition switch to the ON position, unbuckle and then re-buckle the driver's seat belt at least three times, ending with the seat belt BeltAlert Programming The BeltAlert can be enabled or disabled by your buckled. authorized dealer or by performing the following steps: NOTE: Watch for the Seat Belt Reminder Light to turn NOTE: Chrysler LLC does not recommend deactivating on while unbuckling the seat belt and turn off while the BeltAlert . re-buckling the seat belt. It may be necessary to retract the seat belt. 1. With both doors closed, and the ignition switch in any position except ON or START, buckle the driver's seat 4. Turn the ignition switch to the LOCK position. A belt. single chime will sound to signify that you have successfully completed the programming. 2. Turn the ignition switch to the ON position, but do not start the engine. Wait for the Seat Belt Reminder Light to The BeltAlert can be reactivated by repeating this proturn off and then proceed to the next step. cedure. 2